APRILIA eSR1 Manuel De L'utilisateur page 6

• When you use it for the first time, charge the scooter to 100%.
• Activate the electrical circuit, press the power button for a few seconds to start it.
• Check the battery indicator, if the battery is low, recharge it before use, the electric
scooter is a device that requires periodic charging to work.
• Check the tyre pressure (2.5 bar) if the scooter has not travelled at least 60% of the
stated km or reached the maximum speed in the first 3 months of use, it is likely that the
wheels have deflated again, it will thus be necessary to restore the pressure as indicated
(2.5 bar)
• Place the scooter on a flat surface
• Put your hands on the handlebar. Step onto the footplate with one foot and use the other
to give yourself a gentle push and accelerate.
NOTICE
The accelerator is activated once the forward speed exceeds 3 km/h.
For safety reasons, the scooter is initially set up to avoid a standing start.
• When the scooter begins to move, place both feet on the footplate and press the
accelerator.
• To drive the scooter, tilt your body in the direction of travel when turning and slowly turn
the handlebars.
• To stop the scooter, release the accelerator and press the electronic or lever brake on the
left side of the handlebar.
• To dismount, first stop the scooter completely. Trying to get off the scooter while it is in
motion can cause injury.
• When you want to change speed mode, double click on the on/off button (button B in
chapter 5).
• When driving at night or in dark places, double click the button to turn on the lights, and
wear a reflective vest.ò
For your own safety, wear a helmet and knee pads to protect yourself against falls and
injuries while learning to ride the electric scooter.
The rider assumes all risks for not wearing a helmet or other protective gear.
2. Quick-start guide
04