Urmet 1083/77 Mode D'emploi page 17

• Press third button of the first button module (fifth button) to associate user 0 of column 1 in this manner.
• Set the ID dip-switch to .
• Press first button of the third button module (eleventh button) to associate user 0 of column 2 in this
manner.
• Reset the ID dip-switch in start position.
• Quit advanced configuration mode.
The final configuration will be:
§
The configuration of column 0 is not required if the default settings of the door unit are maintained
because all buttons are assigned to this column.
Repeat the operation on all the main door units.
If the door units are configured as secondary, but each one must call a different group of users, the following
steps can be performed:
• Access to advanced configuration by setting both the two rotary dip-switches to position '9' (the yellow
led turns on);
• Set the ID dip-switch of the call module with the apartment station code that will be associated to the
first button (offset);
§
The offset code can only be included between 0 and 31
• Change the position of AUX dip-switch no. 5 (the call module emits a confirmation tone);
• Set again the AUX dip-switch no. 5 in its previous position (the call module emits a confirmation tone);
• Set again the ID dip-switches in their previous position;
• Exit from the advanced configuration, by setting again the two rotary dip-switches in the positions used
to program the door lock release time and the guaranteed conversation time: the yellow led turns off.
Example:
The secondary call module "A" only calls users form 0 to 10 and the "B" only users from 11 to 18.
• On the call module "B" access to advanced configuration;
• Set the ID dip-switch to 11;
• Move the AUX dip-switch no. 5;
• Set again all the dip-switches in their previous position;
• Exit from the advanced configuration.
DS1083-048
Column 0 start
4 USERS
Column 1 start Column 2 start
6 USERS
P5÷P8
P9÷P12
1083/17 (1)
P1÷P4
OUTPUT
8 USERS
P13÷P16
17