Installation Of Decoration Panel - LG multiV TE Série Manuel D'installation

Installation

Installation of Decoration Panel

The decoration panel has its installation
direction.
1. Temporarily fix two decoration panel fixing screws (hexagon M5 screw) on the unit body. (Tighten by
amount 10mm(3/8 inch) in length.
The fixing screws (hexagon M5 screw) are included the indoor unit box.
2. Remove the air inlet grille from the decoration panel. (Remove the hook for the air inlet grille cord.)
3. Hook the decoration panel key hole (
that the screws reach the key hole edge.
4. Retighten completely two temporarily fixed screws and other two screws. (Total 4 screws)
5. Connect the louver motor connector and display connector.
6. After tightening these screws, install the air inlet grille (including the air filter).
Air conditioner unit
Decoration panel fixing screws
(hexagon M5 screws)
Temporally fitting at 2 places
(Tightening about 10mm)
Decoration panel
CAUTION : Install
certainly the deco-
ration panel.
Cool air leakage
causes sweating.
Water drops fall.
12 Indoor Unit
) on the screws fixed in step above, and slide the panel so
Piping side
Decoration panel fixing screws
(Hexagon M5 screw)
Inlet Grille Inlet Grille Inlet Grille
Good example
Fit the insulator (this part) and
be careful for cool air leakage
Before installing the decoration panel,
always remove the paper template.
Control box cover
Louver motor
Bad example
Air conditioner
unit
Ceiling
board
Decoration panel
Display
Lead wire for
louver motor and
display
Air conditioner unit
Air
Cool air leakage
(no good)
Ceiling
board
Decoration
panel