Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Assembly
Changing the Tool
Before any work on the machine itself, pull
the mains plug.
Clean the tool shank 5 and apply a light coat of
grease.
Tools without Shoulder
Operation
Starting Operation
Observe correct mains voltage! The voltage of
the power source must agree with the voltage
specified on the nameplate of the machine.
Power tools marked with 230 V can also be
operated with 220 V.
Switching On and Off
For low temperatures, the machine reaches the full
impact rate only after a certain time.
This start-up time can be shortened by striking the
chisel in the machine against the floor one time.
Operating Instructions
For the highest possible impact damping, work only
with moderate pressure.
Sharpening Chisels
Good results are only achieved with sharp chisels;
therefore, sharpen the chiselling tools in good time.
This ensures a long service life of the tools and
good working performance.
Re-sharpening
Sharpen chiselling tools using grinding wheels (e. g.
ceramic bonded corundum wheel) with a steady
supply of water. Reference values are shown in the
figure.
Take care that no annealing coloration appears on
the cutting edges; this impairs the hardness of the
chiselling tools.
12
Publicité
Table des Matières
