Electrolux IK1555CR Notice D'utilisation page 59

Problem
A rectangular symbol is
shown instead of numbers
on the Temperature Dis-
play.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the Shopping, or
after changing the tempera-
ture.
Water flows on the rear
plate of the refrigerator.
Water flows into the refrig-
erator.
Possible cause
The temperature in the ap-
pliance is too high.
Temperature sensor prob-
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products to be
frozen were put in at the
same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The Shopping function is
switched on.
This is normal, no error has
occurred.
During the automatic de-
frosting process, frost melts
on the rear plate.
The water outlet is clogged. Clean the water outlet.
Food products prevent that
water flows into the water
collector.
ENGLISH
Solution
Contact a qualified electri-
cian or contact the nearest
Authorized Service Centre.
Contact the nearest Author-
ized Service Centre (the
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible).
Close and open the door.
Contact the nearest Author-
ized Service Centre.
Refer to "Operation" chap-
ter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "Shopping func-
tion".
The compressor starts after
a period of time.
This is correct.
Make sure that food prod-
ucts do not touch the rear
plate.
59