IME Nemo 72 Le Manuel D'installation page 35

Nemo 72 Le
Display
Display is divided into 3 menus, accessible with their relevant function keys:
The quantities and the display modes vary according to the selected connection (3-phase 3- or 4-wire line, single phase, etc.
In the following pages you could find all the displayed measurements based on the selected connection.
Acting on the function keys it is possible to scroll the different available measurements:
U
Phase voltage
Interlinked voltage
Interlinked voltage
Max. voltage value
Voltage harmonic distortion
Voltage harmonic analysis
Voltage peak factor
Phase angle between the voltages
Configuration data*
*See configutation factory setting at page 20
Alarm Diplay
If the meter has been programmed for
Pressing any of the front keys, the display stops blinking.
When the alarm is intervened, press several times
14
I
Phase current and neutral current
Current demand
Max. current demand
Average currents
Current harmonic distortion
Current harmonic analysis
Current peak factor
Phase angle between the currents
Configuration data*
relay output = alarm function
(see point 1.7)
P E .
key, until you display the alarm. page.
Quantity associated with the alarm
Alarm type (min/max)
Active, reactive, apparent, distorting 3-phase power
Active, reactive, apparent phase power
Active, reactive, apparent power
Max. demand active, reactive, apparent power
Phase and 3-phase power factor
Phase angle voltages - Phase and 3-phase current
Frequency
Run hour meter
Configuration data*
, in case of alarm intervention, the display blinks in order to detect the anomaly.
P E .
Total and partial, positive active energy
Total and partial, positive reactive energy
Total and partial, negative active energy
Total and partial, negative reactive energy
Configuration data*
02/18 E02 10783332 WEB E cod.MF72...