Système De Communication Passif Cellulaire D'extensioncâblage Détaillé G Series - Bosch B9512G Guide De L'installateur

26 fr | Guide d'installation ULC
Système de communication passif cellulaire d'extension –
câblage détaillé G Series
BATTERY STATUS
Off: Normal
On: Missing
Quick Flash: Low
Slow Flash:
Charging
Low 12.1 VDC
Load Shed 10.2 VDC
Figure 1.14: Centrale B9512G/B8512G* avec module B44x (cellulaire)
connecté via un module B450
REMARQUES : * les centrales B9512G-E/B8512G-E sont prises
en charge dans la configuration illustrée. Dans cette
configuration, la centrale peut également se connecter jusqu'à
2 modules B430. Dans cette configuration, la centrale prend
également en charge l'IP (les centrales B9512G-E/B8512G-E
nécessitent un module B426, supervisé). Une entrée secteur est
requise (non illustrée).
2020-02 | 05 | F.01U.322.701
Minimum system requirements for Classification in accordance with ANSI/SIA
CP-01-2010. UL Listed and Classified control unit Model B9512G and B8512G.
Do not connect
UL Listed and Classified keypad Model B942, B930, B925F, B926F, B921C,
to a receptacle
B920, B915, D1255RB, D1256RB and D1257RB. UL Listed Local Bell.
controlled by
a switch.
The equipment should be installed in accordance with the NFPA 70 (National Electrical
Code) and NFPA 72 (National Fire Alarm Code).
1 CLASS 2
Depending on the application, the installation may need to be in accordance with one or
more of the following UL standards: UL681, UL1076, UL1641 and C22.1, CEC, Part 1.
16.5 VAC 40 VA 60 Hz
Use of a D185 is not suitable for remote station protected premises service where separate
2 TRANSFORMER
transmissions circuits are required for fire, supervisory (when applicable) and trouble
signals.
All external connections except Terminal 5 (BATTERY(+) are inherently power limited.
3 + AUX POWER
Requirements for battery standby time might reduce allowable output.
POWER SUPPLY REQUIREMENTS
4 BATTERY ( - )
The Power Supply provides a maximum of 1.4 Amps for the Control Panel and all Accessory Devices. For System Loading,
refer to the B9512G/B8512G UL Listing Document, ULLD. Auxiliary powered devices: 11.8 to 12.5 VDC
Battery: Replace every 3 to
The B9512G/B8512G Control Panel is UL Listed For CS, RS, L, AUX, Prop and Res Fire and Res, Prop,
5 BATTERY ( + )
5 years with one or two
Cent. Stat, Local, and PS Con. Merc. Burg, MSV, BSV, Holdup, suitable as a dual line trans. sys.
Model D126 or D1218 12V
Signaling means: DAC, Cell or IP
Lead Acid Batteries.
OUTPUT
6
A (1)
The system is intended to be checked by a Qualified Technician at least every 3 years. The types of initiating circuits the control
panel has been approved for are A, M, WF, SS. The types of signaling the control panel has been approved for are DAC, OT, NC,
OUTPUT
RevPol.
7
B (2)
Refer to the system wiring diagrams in the B9512G/B8512G
WARNING!
To prevent risk of shock, ULLD and to the D125B Installation Instructions for compatible
OUTPUT
8
disconnect AC power and smoke detectors. 2-wire Compatible Identifier "A". Printed
C (3)
communication lines before
information describing proper installation, operation, testing,
servicing.
maintenance, repair service and response to an alarm is to be
9 COMMON
ON-BOARD POINTS
10 EARTH GROUND
WARNING! WARNING!
Multi-Battery Incorrect wiring will
installation requires damage this
Model D122 or D122L equipment.
Point 1 Point 2
Dual Battery Harness. Devices powered by
Improper installation any output must be
11 12
can be a fire hazard . supervised.
B
USB POWER
A
STATUS
L
S
I
E
N
K T
POINT 1 COM POINT 2 POINT 3 COM POINT 4
USB ETHERNET
provided with this equipment.
WARNING!
Owner Instructions (P/N F.01U.307.371): Not to
be removed by anyone except occupant.
Voltage Ranges: Open 3.7 - 5.0 VDC, Short 0.0 - 1.3 VDC, Normal 2.0 - 3.0 VDC
1 k End-of-line-Resistors Required (P/N 15093130-004), Max Loop Current: 5 mA
Point 3 Point 4 Point 5 Point 6 Point 7 Point 8
13 14 15 16 17 18 19 20 21
POINT 5 COM POINT 6 POINT 7 COM POINT 8
SIM
B44x
Antenna
B450
MOD-2
MODULE RELEASE
MOD-1
PWR+/R 30
29
A/Y
28
B/G
27
COM/B
PWR+/R 26
A/Y 25
B/G 24
COM/B 23
22
ZONEX TMPR RESET
ZONEX TMPR
B915/B915I/B920)
Bosch Security Systems B.V.
Control Panels
Keypad
(models