Parameter Setting Menu - glass 1989 SAUNE Notice D'utilisation

settings combined to it.
ATTENTION: If no selection is made
within 5 seconds, the keyboard will go
back to STAND-BY mode.
Using it is possible to switch off all
the active functions, by touching a single
EN
button.
If automatic programming is enabled, the
keyboard goes to the active functions status
"FUNCT. ON".
In this case you may:
manage status of the LIGHT or
CHROMOTHERAPY function.
interrupt "sauna AUTO", if on.
press
SAUNA functions.
go to the "READY" status, if no button
is pressed and no function is active
after 5 seconds.

PARAMETER SETTING MENU

DATE/TIME SETTINGS
With the keyboard in "READY" mode,
press and hold the key
to access the date and time setting mode.
In this mode, the key
editable value is viewed in negative and can
and to move from one value to the next.
Pressing the key
effective. If the keys
pressed for 5 seconds, you exit the date
setting mode and return to "READY" status.
01-01-2014
OPERATION IN SAUNA MODE
The display on the keyboard (display/keys)
depends on the function status.
SAUNA ON
When the function is active (both because
to switch off the LIGHT and
for 2 seconds
and ; press
during the minutes
, , and
10:00
20°C
activated in manual mode or in automatic
mode) the key
high intensity and the display shows:
the current temperature of the sauna
time remaining until the end of the
function.
indication whether the function was
activated manually (MAN) or by the
program (AUTO).
The set point temperature can be changed
at any time by pressing
time and
temperature are replaced by the set point
value displayed in negative, indicating that
you have entered "
mode. Then press the keys to modify
the values. If
for 3 seconds, you exit the "set point
When the keyboard is in "READY" status
and the sauna is not on, the LED associated
to the key
SAUNA CONFIGURATION IN MANUAL
MODE
In this mode you may:
- activate MANUAL sauna mode with the set
point and set duration (by pressing
- select and modify the set point and
duration of the MANUAL sauna.
- select and enter (
are not
the automatic sauna function
The display views the following data:
- in negative, indicating the possibility of
modifying the set point temperature of
the last sauna (the default temperature
value is 90°C);
-the default duration (6 hours) in "h:mm"
format;
- "MAN" and "AUTO" modes with "MAN"
underlined with a dash indicating that it is
selected.
Selection
You may shift selection to the four possible
24
is on steady WHITE at
and
are pressed, the digits of the
and are not pressed
" mode.
is off. If the sauna has been
) in the screen to set
).