glass 1989 SAUNE Notice D'utilisation page 51

and buttons until the word ''Duration''
''MENU/OK'' button. The display shows
a message saying ''SAUNA_SET'' ''Start-
duration_00:00'' or the last message set.
Set the desired duration of the session with
the and buttons (e.g. 2:30).
Press the ''MENU/OK''
m e s s a g e s a y i n g ' ' S A U N A _ O F F ' '
''Duration_STOP'' appears on the display.
The duration of the session is set.
NOTE: if the settings do not change within
20 seconds, you will automatically exit the
programming.
Sauna temperature
You can set the heating temperature from
15°C to 110°C.
To go to the programming mode, press the
and buttons until the ''Temperature''
with the ''MENU/OK'' button, the display
shows a message saying ''SAUNA_SET''
''Temperature_90°C'' or the last message
set.
Set the desired temperature with the
and buttons (e.g. 95°C).
Press the ''MENU/OK''
m e s s a g e s a y i n g ' ' S A U N A _ O F F ' '
''Temperature_actual temperature''
appears on the display.
The temperature is set.
NOTE: if the settings do not change within
20 seconds, you will automatically exit the
programming.
FAN
(not supplied with the sauna)
If there is a fan installed in the sauna, it
can be connected to the control unit and
controlled by the command mentioned
above.
The fan speed can be set from 0 (off) to
100%.
NOTE: If there is no fan installed: select
0% = OFF
To go to the programming mode, press
the and buttons until the word ''Fan''
"MENU/OK" button. The display shows
"SAUNA_SET" "Fan_60%" or the value
previously entered.
Set the desired temperature with the
and buttons (e.g. 80%).
Press the ''MENU/OK''
message saying ''SAUNA _OFF'' ''Fan_
OFF'' appears on the display.
The fan status is set.
NOTE: if the settings do not change within
20 seconds, you will automatically exit the
programming.
Turning the automatic mode on / off
The automatic mode can be activated after
the programming stage.
Press the and
selection with the "MENU/OK" button.
The display will show a message saying
"SAUNA_SEND" "Automatic_ON" and
after a few seconds the confirmation
message "SAUNA_AUTO" appears,
switching to the "Start-Time_18:30"
parameter.
The automatic mode is on. The system
starts heating at the set time.
To turn off the automatic mode, press
the and button until the the word
"Automatic" appears. Confirm the
selection with the ''MENU/OK'' button.
The display will show a message saying
''SAUNA_SEND'' ''Automatic_OFF'' and
after a few seconds the confirmation
message "SAUNA_OFF" "Automatic_
OFF" appears.
The automatic mode is off.
When the sauna turns off, an acoustic
signal is emitted and the display shows
a message saying "SAUNA_OFF" and
"Duration_STOP" appears in the session
19
button until the
EN