Replacing The Bulb - AIRLUX AHB682IX Mode D'emploi

button and power button
will stop. Indicator light of middle button and power button will be off,and run by circle.
6. Press the (low) button once, motor runs on low speed, the indicator light of low
button and power button
stop. Indicator light of low button and power button will be off,and run by circle.
7. Low speed, mid speed and high speed cannot work at the same time. When hood is on high
speed, press low speed, it will turn to low speed at once; when it is in low speed, press
middle speed, it will turn to middle speed immediately, and so on.
CARBON FILTER REPLACMENT
Activated carbon filter can be used to trap odors. Normally the activated carbon filter should
be changed every 3 to 6 months according to your cooking habits. The installation procedure of
new activated carbon filter is as below:
(1) The aluminum filter should be detached first. Press the lock and pull it downward.
(2) Take out the old carbon filter by rotating the carbon filter anti-clockwise.
(3) Replace the new carbon filter.
-Apply reverse procedure to uninstall the charcoal filter
NOTE:
• Make sure the filter is securely locked. Otherwise, it would loosen and cause danger.
• When activated carbon filter attached, the suction power will be lowered.
REPLACING THE
➢ Remove the grease filter.
➢
Use a tool or the hand to press the spring splinter of both sides of LED light to the
until the light is pressed out, see pic 1.Then slightly pull the light connecting wire out, and
dismantle the terminal of the light connecting wire. See pic 2.
will beam. Press middle button
will beam. Press low button
BULB:
67
again and the motor
again and the motor will
inside,