AIRLUX AHB682IX Mode D'emploi page 65

inside chimney bracket and screw 2pcs ST4 × 30mm screws on the wall with wall plugs. The
screws(ST4 × 30mm) installed should leave for 3-5mm out of the wall to hang the hood. See
pic 2.
3. Install the v-flap and adaptor on the outlet. Put the cooker hood on the wall mounted
screws. See pic 3 & 4.
4. Afterwards, fix the outside chimney bracket on the outside chimney with 2 pcs ST4*8mm
screws, and be sure that the inside chimney can be adjusted the height in it freely. Install
the chimneys on the cooker hood. After adjusting the position, fix the body with safety
screws. Note: The two safety vents are positioned on the back housing, with a diameter of
6mm. See Pic 5 & Pic 6.
5. Adjust the height of the inside chimney to the position of the inside chimney bracket and
fix it by screws. See Pic 7.
Carbon filter installation：
(1) The aluminum filter should be detached first. Press the lock and pull it downward.
(2) Install the carbon filter by rotating the carbon filter clockwise.
65