Circular Saw Safety - GMC LS1200 Traduction Des Instructions Originales

d. Store idle power tools out of the reach of children and do
not allow persons unfamiliar with the power tool or these
instructions to operate the power tool. Power tools are dangerous
in the hands of untrained users.
e. Maintain power tools. Check for misalignment or binding of
moving parts, breakage of parts and any other condition that
may affect the power tool's operation. If damaged, have the
power tool repaired before use. Many accidents are caused by
poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly maintained cutting
tools with sharp cutting edges are
less likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits etc. in accordance
with these instructions, taking into account the working
conditions and the work to be performed. Use of the power
tool for operations different from those intended could result in a
hazardous situation.
5. SERVICE
a. Have your power tool se rviced by a qualified repair person
using only identical replacement parts.
This will ensure that the safety of the power tool is maintained.

CIRCULAR SAW SAFETY

WARNINGS. Before connecting a tool to a power source (mains switch
power point receptacle, outlet, etc.) be sure that the voltage supply
is the same as that specified on the nameplate of the tool. A power
source with a voltage greater than that specified for the tool can result
in serious injury to the user, and damage to the tool. If in doubt, do
not plug in the tool. Using a power source with a voltage less than the
nameplate rating is harmful to the motor.
• Do not allow anyone under the age of 18 years to operate this saw
• When operating the saw, use safety equipment including safety
goggles or shield, ear protection, dust mask and protective clothing
including safety gloves
• Hand-held power tools may produce vibration. Vibration can cause
disease. Gloves may help to maintain good blood circulation in the
fingers. Hand-held tools should not be used for long periods without
a break
• Always use recommended blades with correct size and shape of
arbor holes e.g. diamond or round. Blades that do not match the
mounting hardware of the saw will run eccentrically, causing loss
of control
• Whenever possible, use a vacuum dust extraction system to control
dust/waste
• Power tools must always be held by the insulated gripping surfaces
when performing an operation, ensuring protection if the cutting tool
makes contact with its own cord or hidden wiring. Contact with a
'live' wire will make exposed metal parts of the power tool 'live' and
shock the operator if the insulated gripping surfaces are not used
• Ensure hands are away from the cutting area and blade. Keep
one hand on auxiliary handle, or motor housing. If both hands are
holding the tool they cannot be cut by the blade
• Do not attempt to cut material thicker than detailed in the
Specifications section of this manual
• Adjust the cutting depth to the thickness of the workpiece i.e. less
than a full tooth of the blade should be visible below the workpiece
• Ensure that work is correctly supported. Large panels may sag
under their own weight and bind the saw blade. Supports must be
placed under the panel on both sides, close to the line of cut and
near the edge of the panel
• Ensure all supports and power cables are completely clear of the
cutting path
• Always secure the workpiece to a stable platform, ensuring that
body exposure is minimised, avoiding blade binding or loss of control
• For accuracy of cut, and to avoid blade binding, always use a rip
fence or straight edge guide
• Never hold a workpiece in your hand or across your legs whilst cutting
• Always stand to one side when operating the saw
5
GB