Honeywell HUT-220 Serie Manuel D'utilisation page 9

RE-ASSEMBLING: HUT-220 Series
STEP 1
Reassemble pump by
inserting impeller disk
with blades facing front
housing onto front hous-
ing shaft. Replace back
cover and turn clock-
wise to lock in place.
STEP 4
Insert demineralization
cartridge into slot and
gently press into place.
Note: Please be careful of clothing, rugs and other non bleach resistant materials when
disinfecting. Spilling bleach on clothing, rugs and certain surfaces may cause damage.
END-OF-SEASON CARE AND STORAGE
Follow the CLEANING instructions when the humidifier will not be used for at least one week or more, or
at the end of the season.
At the end of the season, remove demineralization cartridge and allow to dry properly.
Note: If demineralization cartridge has been used you should replace it with a new cartridge.
Dry the humidifier completely before storing. DO NOT store with water inside the main housing water
reservoir or water tube.
Pack unit in original carton and store in a cool, dry location.
Install new demineralization cartridge before next use.
Do Not Re-Assemble
Pump with impeller disk
blades facing towards
back cover. Incorrect
assembly will not allow
you to attach rear cover.
STEP 5
Attach water hose
opening to demineraliza-
tion cartridge by gently
inserting cartridge outlet
into water hose opening.
STEP 2
Insert pump outlet into
hose and gently press
all the way on until it
cannot go any further.
STEP 6
Replace mist nozzle by
gently snapping into
place.
STEP 3
Insert water pump/
hose assembly into slot
in base.
Note: please be sure
pump is fully seated
and there are no kinks
in the hose.
STEP 7
Replace top housing and
protective clear cover.
9