MAXOAK BLUETTI EB150 Mode D'emploi page 8

How to charge the product
Charge with solar power
To charge the product, insert the solar charging cable or AC adapter into the input port
of the product. The display screen would light up and the charging power would be
displayed. But don't care this the wrong way. The product will not turn on by itself when
being charged. If the product is previously turned off, it will remain turned off unless you
manually turn it on.
Charge with AC power
Insert one end of the adapter into wall outlet and insert the other end to the input port of
the product. Then, the product will be charged and you can monitor the battery status by
checking the battery icon on the LCD screen The product comes with a built-in advanced
control circuit. When the battery is fully charged, it will stop charging itself automatically.
Cold Weather
Cold weather can influence battery capacity. In sub-zero temperature (<0°C), you may
be able to discharge the product, but you should not charge it. Otherwise, the battery of
the product would be greatly damaged and the capacity may not even be recovered.
Low temperature charging protection: When the product is charged at a temperature
below 0°C, it will shut off and stop charging itself automatically. The product will reboot
and start charging itself when the temperature rise to above 10°C.
Low temperature discharging protection: If the product is discharged at a temperature
of -20°C, it will turn off. The product will reboot and turn on output when the temperature
rise to above -10°C.
EN-05