Troubleshooting Schedule - Husqvarna 120i Manuel D'utilisation

Troubleshooting schedule

Keypad
Possible fault codes on the chain saw keypad.
Keypad
Warning indicator flashing.
Green activate LED flashing.
Warning indicator lit.
Battery
Troubleshooting the battery and/or the battery charger during charging.
LED display
Warning indicator flashing.
Warning indicator lit.
Battery charger
LED display
Error LED flashing
Red LED on
30 – English
MAINTENANCE
Possible faults
Chain brake engaged.
Temperature deviation.
Overload. Cutting attachment
jammed.
The power trigger and the activate
button are pressed at the same time.
Low battery voltage.
Service
Possible faults
Temperature deviation.
Over voltage.
Under voltage
Cell difference too much (1V).
Possible faults
Temperature deviation.
Cell difference too much (1V).
Possible action
Pull back the front hand guard to release
the chain brake.
Allow the machine to cool down.
The cutting attachment is jammed.
Release the cutting attachment.
Release the power trigger and the
machine is active.
Charge the battery.
Contact your service agent.
Possible action
Use the battery in surroundings where
temperatures are between -10 °C and 40
°C.
Check that the mains voltage corresponds
with that stated on the rating plate on the
machine.
Remove the battery from the battery
charger.
Charge the battery.
Contact your service agent.
Possible action
Use the battery charger only when the
surrounding temperature is between 5 °C
and 40 °C.
Contact your service agent.