Lighting Instructions - eurodib T-CBR15 Instructions D'installation Et D'utilisation

8. Reinstall the U burners.
9. Check leakage and reinstall the other parts.
10. Ignite the pilot burner and check flame state.
11. Turn the knobs to "High".
If the U burner does not ignite, open the pilot valve more.
If the pilot flame appears larger than necessary, turn it down and reset burner ignition.
The pilot flame should be as small as possible but large enough to guarantee a
reliable ignition of the burners when the knobs are turned to "ON.
Note: Please check leakage before reinstalling the control-panel.
Lighting the Pilot
The pilot light on the appliance has been set at the factory. A screwdriver maybe required for
the first lighting to adjust the flame for your elevation.
1. Turn off the manual valve and wait 5 minutes to clear the air gas.
2. Turn all knobs to the "OFF" position.
3. Hold an ignition source (match) at the pilot. When the flame is established, remove the
ignition source.
4. Turn the burner knobs to "ON". If the burner does not ignite, promptly open the pilot
valve more. If the pilot flame appears larger than necessary, turn it down and reset
burner ignition. The pilot flame should be as small as possible but large enough to
guarantee a reliable ignition of the burners when the knobs are turned to "ON".
Lighting the Main Burner
To light burner, turn the knob to "ON." Then back off to the desired flame level. The range of
adjustment is virtually infinite between "ON" and "OFF".
Main burner air supply
For efficient burner operation, a proper balance of the gas volume and primary air supply
must be maintained, which will result in a complete combustion. Insufficient air supply results
in a yellow streaming flame. The primary air supply is controlled by an air shutter on the front
of the burner.
Loosen the screws on the front of the burner and adjust the air shutter to just eliminate the
yellow tips of the burner flame. Lock the air shutter in place by tightening the screws.

LIGHTING INSTRUCTIONS

10