Mitsubishi Electric City Multi PLFY-P15VFM-E1 Manuel D'installation page 11

Manual vane angle
Main Main menu
Maintenance
Initial setting
Service
Main display:
Cursor Page
F1 F2 F3 F4
Maintenance menu
Auto descending panel
Manual vane angle
3D i-See sensor
Main menu:
Cursor
F1 F2 F3 F4
Manual vane angle
M-NET address
Identify unit Check button
Input display:
Address Check
F1 F2 F3 F4
Manual vane angle
Select:
Outlet Angle
F1 F2 F3 F4
Manual vane angle
Setting
1 Select "Maintenance" from the Main
button.
2 Select "Manual vane angle" with
3 Select the "M-NET address" for
the units to whose vanes are to be
unit.
The vane of only the target indoor
unit is pointing downward.
4 The current vane setting will appear.
Select the desired outlets from 1
4, (all outlets)"
through the option in the order of
"No setting (reset)," "Step 1", "Step
2", "Step 3", "Step 4", "Step 5" and
"Draft reduction*".
Select the desired setting.
* Draft reduction
T h e a i r f l o w d i r e c t i o n f o r t h i s
setting is more horizontal than the
airflow direction for the "Step 1"
setting in order to reduce a drafty
feeling. The draft reduction can be
set for only 1 vane.
Vane setting
No setting Step 1
Step 3 Step 4
Draft All
reduction* outlets
A screen will appear that indicates the setting information is being
transmitted.
The setting changes will be made to the selected outlet.
The screen will automatically return to the one shown above (step 5)
when the transmission is completed.
Make the settings for other outlets, following the same procedures.
If all outlets are selected,
goes into operation.
Navigating through the screens
.........................
....................
Manual vane angle
M-NET address
Identify unit Check button
Input display:
Address Check
F1 F2 F3 F4
Manual vane angle
M-NET address
Function setting for unit
with vane fully open.
Return:
F1 F2 F3 F4
Manual vane angle
No communication
Check Unit state.
Return:
F1 F2 F3 F4
Step 2
Step 5
1 Select the "M-NET address" for
the units to whose vanes are to be
the unit.
2
wait approximately 15 seconds,
and then check the current state
of the air conditioner.
on the remote controller.
ue the operation from the begin-
ning.
device does not exist at this refrig-
erant address.
turn to the initial screen.
3 Change the "M-NET address" to
the next number.
1 to change the
"M-NET address" and continue
11
-
-