Device Description; Specified Conditions Of Use; Requirements For The User; Technical Data - Kress Elektrowerkzeuge 1300 ABH Mode D'emploi

Device description

3. Device description
Read all the warnings and instruc-
tions before using the equipment.
Failure to follow the warnings and
instructions may result in electric
shock, fire and/or serious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Device components
1 Tool insert
2 Clamping lever
3 Auxiliary handle
4 On/Off switch
5 Handle
6 Cover for brushes
7 Ventilation slots
8 Oil level display / Plug screw
9 Tool shaft groove
10 Retaining screws
Scope of supply
See packaging

Specified Conditions of Use

The breaker is designed for heavy chiselling and
demolition work and, if fitted with the correspond-
ing accessories, for tamping and compacting.

Requirements for the user

The tool must only be operated, maintained and
serviced by authorised trained personnel. The
personnel must be made aware of the relevant
dangers.

Technical data

Input power
Tool holding fixture
Individual impact power
Protection class
Weight
The machine is radio and TV interference-free in
accordance with EN 55014-1 and interference-
proof in accordance with EN 55014-2.
Brief drops in voltage occur at the moment when
W 1300
'' SW 30
J 39.5
kg 15
equipment is switched on. Under unfavourable
mains conditions, this may impair the operation of
other devices. Interference is unlikely where
mains impedance is lower than 0.25 Ohm.
Noise and Vibration Information
Noise levels
Measurement values determined according to EN
60 745.
The A-weighted noise level of the device is typical-
ly:
Sound pressure level (L
Sound power level (L
Measurement uncertainty K = 3 dB
The noise level can exceed 85 dB(A)
during operation.
Wear ear protection!
Vibration
Triaxial vibration emission level determined in ac-
cordance with EN 60745.
Chiselling
Measurement uncertainty K
The vibration emission level given in
this information sheet has been
measured in accordance with a
standardised test given in EN 60745
and may be used to compare one
tool with another.
The vibration emission level will vary because of
the ways in which a power tool can be used and
may increase above the level given in this infor-
mation sheet. This could lead to underestimation
of vibration when the tool is used regularly in such
a manner.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given
period of work should also take into account the
times when the tool is switched off and when it is
running but not actually when doing the job.
This may significantly reduce the exposure level
over the total working period.
I
English 15
) 93 dB(A)
pA
) 104 dB(A)
wA
m/s²
m/s²
1300ABH-EN / 0903
EN
15
1,5