Cabling - Atlantis NetFly AP3 WN Guide Rapide

LED
WLAN Lit green when the wireless function is enabled.
Blinking when data is transmitted or received via WLAN.
Blinking quickly when WPS is proceeded.
POWER Lit green when the device is power on.
Lit off when power is off.
ETH Lit green when connected to an Ethernet device.
Blinking when data is transmitted or received via Ethernet port.
BUTTON
WPS Push this button to trigger Wi-Fi Protected Setup function.
RESET Press this button 3 seconds to reset device to factory default settings.

5. Cabling

Plug NetFly AP3 WN into the wall outlet/socket.
With the power source on, once the device is connected, the Power, LAN and WLAN
port LEDs will light up indicating a normal status.
If the LAN Port's Link indicator does not light up then check the RJ-45 cable if it is
firmly feed to the RJ45 port, while the LAN is link up to the Switch/Hub, the LAN
port's LED will light up.
The control LEDs of the device are clearly visible and the status of the network link
can be seen instantly.
MEANING
MEANING
33