Cabling; Factory Default Settings - Atlantis NetFly AP4 WN+ Guide D'installation Rapide

1.5 Cabling

First you must connect the product to the RJ45 ports the PCs of your Lan or others
Switch. In the end connect the DC Adapter to the socket then to the NetFly AP4.
Once you've done all the connections the product will carry on immediately a
autotest (120 seconds). With the power source on, once the device is connected,
the Power, LAN and WLAN port LEDs will light up indicating a normal status.
If the LAN Port's Link indicator does not light up then check the RJ-45 cable if it is
firmly feed to the RJ45 port, while the LAN is link up to the Switch/Hub, the LAN
port's LED will light up.
The control LEDs of the device are clearly visible and the status of the network link
can be seen instantly.

1.6 Factory Default Settings

The Wireless Multi-Function Access Point can be configured with your Web browser.
The product provides a very easy and user-friendly interface for configuration.
29