Typical Vent Installations - Napoleon LV50N Instructions D'installation Et D'opération

Table des Matières

Les langues disponibles

kit GD411, ﬂ at roof terminal kit GD412 or periscope kit GD401 (for wall penetration below grade). With ﬂ exible venting,

in conjunction with the various terminations, use either the 5 foot (1.5m) vent kit GD420 or the 10 foot (3.1m) vent kit

GD430.

EN EN

For optimum ﬂ ame appearance and appliance performance, keep the vent length and number of elbows to a

minimum.

The air terminal must remain unobstructed at all times. Examine the air terminal at least once a year to verify

that it is unobstructed and undamaged.

Rigid and ﬂ exible venting systems must not be combined. Different venting manufacturer components must

not be combined.

These vent kits allow for either horizontal or vertical venting of the appliance. The maximum allowable horizontal

run is 20 feet (6.1m). The maximum allowable vertical vent length is 40 feet (12.2m). The maximum number of vent

connections is two horizontally or three vertically (excluding the appliance and the air terminal connections) when

using ﬂ exible venting.

Horizontal runs may have a 0" (0mm) rise per foot/meter however for optimum performance it is recommended

that all horizontal runs have a minimum 1/4" (6.4mm) rise per foot/meter using ﬂ exible venting. For safe and proper

operation of the appliance, follow the venting instructions exactly.

A terminal shall not terminate directly above a sidewalk or paved driveway which is located between two single family

dwellings and serves both dwellings. Local codes or regulations may require different clearances.

Do not allow the inside liner to bunch up on horizontal or vertical runs and elbows. Keep it pulled tight. A 1¼"

(31.8mm) air gap all around between the inner liner and outer liner is required for safe operation.

3.2