Napoleon PRO665 Mode D'emploi page 16

16
WARNING!
of grease. To prevent grease fires, the pan must be cleaned after each use.
EN
WARNING!
conditions exist, do not use the gas grill. Have the part replaced by your Napoleon Grill dealer or
qualified gas installer.
Aluminum Castings: Clean castings periodically with warm soapy water. Aluminum will not rust, but high
temperatures and weathering can cause oxidation to occur on aluminum surfaces. This appears as white
spots on the castings. To refinish these areas, clean first and sand lightly with fine sandpaper. Wipe the
surface to remove any residue and paint with high temperature barbecue paint. Protect surrounding areas
from over-spray. Follow the manufacture's directions for curing.
WARNING!
of your grill.
Lights: To replace the halogen bulb in your grill you must first remove the lens from the light housing.
To remove the lens from the housing, remove the Philips screw securing the housing in place. Snap the
lens out of the housing (including the metal bracket). Do not touch the halogen bulb with your bare hands.
The oil from your fingertips will reduce the life of the bulb. With gloved hands gently pull the old bulb
from the socket and replace with the new bulb. Reinstall the lens, by snapping it back into the housing
and bend the tabs on the front of the housing back in to position.
www.napoleongrills.com
The Infrared side burner is supplied with a drip pan which holds only a minimal amount
Hose: Check for abrasions, melting, cuts, and cracks in the hose. If any of these
Always wear protective gloves when changing the halogen bulb in the internal lights
1
3
2
N415-0423 MAY 09.18