Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3510 2610008262 ENG:SM 2610008262 12-09 3/26/10 9:03 AM Page 15
STRAIGHT CUTS USING FENCE
Straight cuts are easy to do with a FENCE
(Fig. 13). To attach fence, insert fence
through slots in foot to desired width as
shown and secure with the FENCE
ADJUSTMENT NUT.
SERVICE
Preventive maintenance
WARNING
!
performed by unauthorized
personnel may result in misplacing of
internal wires and components, which
could
cause
recommend that all tool service be performed
by a Skil Factory Service Center or
Authorized Skil Service Station.
Tool Lubrication
Your Skil tool has been properly lubricated
and is ready to use. It is recommended that
tools with gears be regreased with a special
gear lubricant at every brush change.
Carbon Brushes
The brushes and commutator in your tool
have been engineered for many hours of
dependable service. To maintain peak
efficiency of the motor, we recommend every
two to six months the brushes be examined.
Replace the brushes when they wear down
to approximately 3/16 in. (4.8 mm) or when
excessive sparking occurs within the motor
housing. Brushes on both sides of the motor
should be replaced at the same time. Only
genuine Skil replacement brushes specially
designed for your tool should be used.
Bearings
After about 300-400 hours of operation, or at
every second brush change, the bearings
should be replaced at Skil Factory Service
Maintenance
serious
hazard.
DESIRED
WIDTH
OF CUT
Center or Authorized Skil Service Station.
Bearings which become noisy (due to heavy
load or very abrasive material cutting) should
be replaced at once to avoid overheating or
motor failure.
We
WARNING
!
the power supply before cleaning or
performing any maintenance. The tool may
be cleaned most effectively with compressed
dry air. Always wear safety goggles when
cleaning tools with compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through openings.
CAUTION
!
plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning
solvents,
ammonia
detergents that contain ammonia.
CARE OF BLADES
Blades become dull even from regular
cutting. If you find yourself forcing the saw
forward to cut instead of guiding it through
the cut, replace the blade.
-15-
Fig. 13
FENCE
ADJUSTMENT
NUT
FENCE
CLEANING
To avoid accidents, always
disconnect the tool from
Certain cleaning agents
and
solvents
damage
and
household
Publicité
Table des Matières
