KRONAsteel KAMILLA slim 500 Guide De L'utilisateur page 12

EN Application sheet
that do not contain acids or washed after pre-
liminary soaking in hot water using an ef-
ficient detergent or, if possible, in the dish-
washer (at a temperature of 65°C). Extremely
polluted grease trap filters should not be
washed in the dish-washer along with kitch-
enware. Aluminum filters should be cleaned
once in 1.5-2 months, which will be remind-
ed by a relevant signal on the display of the
kitchen hood remote control (see the remote
control description in the paragraph "Kitchen
hood control").
Simultaneously with cleaning of the grease
trap filter, clean all the accessible elements of
the kitchen hood case from grease deposits.
To disconnect the aluminum filter (Fig. 9),
press the spring lock on the filter and pull it
and then press down to remove. When you
remove the filter, do not apply the effort to the
aluminum surface of the filter as it may lead
to dents on its surface, affecting the external
appearance of the filter.
Do not install the filter in the kitchen hood
until it is completely dry. The filter is installed
in the reverse order. Press the spring lock on
the filter and put it in place, after which re-
lease the lock.
Charcoal filters should be changed once in
5 months. They are installed on protective
grids of the engine case by slight pressing
and turning them clockwise. To remove the
charcoal filter, press it slightly and turn it an-
ticlockwise (Fig. 10).
Replacement of light bulbs
Lighting on the kitchen hood is provided by
two halogen bulbs. To replace the light bulbs,
remove the aluminum grease trap filter. In the
rear part of the cartridge are located with 1
or 2 lamps (depending on model). Rotate the
burned-out lamp and replace it with a new
12
KITCHEN HOODS
one (figure 11) with the same characteristics.
After the bulbs have been replaced, re-install
the aluminum grease trap filter.
Caution!
The bulbs are very hot. To avoid burns,
replace the bulbs only when the kitchen
hood is switched off.
Caution!
The kitchen hood light bulbs are not
for long-term use as kitchen lighting.
Long-term work of light bulbs may result
in early breakdown of the bulbs and the
kitchen hood
Replacement of bulbs and filters is not
included in the warranty service.
KITCHEN HOOD INSTALLATION
The kitchen hood should be installed
and connected to power supply only by a
specialist.
Do not start mounting the kitchen hood and
removing the protective film until you make
sure that the kitchen hood is in working or-
der by connecting it to the power supply and
checking all its functions.
For this purpose, locate the hood case (see
Fig. 1) in such a way as to make it comfort-
able to relocate the lower sliding panel to the
extreme front position and ensure free ac-
cess to work modes switch. Then the kitchen
hood is connected to the power supply and
checked.
If the kitchen hood works correctly in all
modes, start mounting. If not, contact the
INSTRUCTIONS