Filling With Rinse Aid And Making The Setting - Everglades EVBI510 Mode D'emploi

They produce good results for certain types of usage only. If you are using this type of
•
detergents, you need to contact the manufacturers and find out about the suitable conditions of
use.
When the conditions of use of such products and the machine settings are appropriate, they
•
ensure savings in salt and/or rinse aid consumption.
Contact the detergent manufacturers if you are not obtaining good wash results (if your dishes
•
stay calcareous and wet) after having used 2 in 1 or 3 in 1 detergents. The scope of warranty for
your machine does not cover any complaints caused by the use of these types of detergents.
Recommended usage: If you want to obtain better results while using combined detergents, add salt
and rinse aid into your machine and adjust the water hardness setting and the rinse aid setting to the
lowest position.
Solubility of the tablet detergents produced by different companies can vary depending on the
temperature and time. Therefore, it is not recommended to use such detergents in short programs.
It is more suitable to use powder detergents in such programs.
Warning: Should any problem, which you have not encountered before, arise with the use of this type
of detergents, contact the detergent manufacturers directly.
When you give up using combined detergents
Fill the salt and rinse aid compartments.
•
Adjust the water hardness setting to the highest position and run an empty-wash.
•
Adjust the water hardness level.
•
Make the suitable rinse aid setting.
•

Filling with rinse aid and making the setting.

Rinse aid is used to prevent the stay of white water drops, lime stains, white film strip-shaped
the rinse aid compartment with rinse aid until the rinse aid level
You need to increase the degree of the adjuster if water stains form on your dishes after a
wash, whereas you need to decrease the degree if a blue stain is left when wiped by
Warning: Use only those rinse aid materials which are allowed for use in the machine. As rinse aid
residues left as a result of overflowing will create extremely high amounts of foam and thus reduce the
washing performance, remove the excess amount of rinse aid by wiping it with a rag.
stains that may form on the dishes, as well as to increase the drying
performance. Contrary to the popular beliefs, it is used not only for
obtaining shinier dishes but also for obtaining sufficiently dried dishes. For
this reason, care should be taken that
there is adequate amount of rinse aid
in the rinse aid compartment and only
polishing material produced for use at
dishwashers should be used.
To put rinse aid, remove the rinse aid
compartment cap by turning
indicator becomes
cap and close it by turning it in a way
that the nails will correspond to one
another. By checking the rinse aid level indicator on the detergent
dispenser, you can understand whether or not your machine needs rinse
aid. A dark indicator
while a light indicator
rinse aid.
The rinse aid level adjuster can be set to a position between 1 and 6.
Factory setting for rinse aid is the position 3.
41
it.1 Fill
dark;2 refit the
b means that there is rinse aid in the compartment,
a shows that you need to fill the compartment with
hand.3