Important Notes For Users In The U.k; Mains Plug; How To Connect A Plug - Dual DTJ 301 USB Manuel D'utilisation

Important notes for users in the U.K.

Important notes for users in the U.K.

Mains plug

This apparatus is fitted with an approved 13 Amp plug.
To change a fuse in this type of plug proceed as follows:
1. Remove fuse cover and fuse.
2. Fix new fuse which should be a BS1362 3 Amp,
A.S.T.A. or BSI approved type.
3. Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it
should be cut off and an appropriate plug fitted in its
place. If the mains plug contains a fuse, this should have
a value of 3 Amp. If a plug without a fuse is used, the
fuse at the distribution board should not be greater than
5 Amp.
Note:
The severed plug must be disposed of to avoid a
possible shock hazard should it be inserted into a 13
Amp socket elsewhere.
4

How to connect a plug

The wires in the mains lead are coloured with the
following code:
blue = neutral (N), brown = live (L).
As these colours may not correspond with the colour
markings identifying the terminals in your plug,
proceed as follows:
Connect the blue wire to the terminal marked N
or coloured black.
Connect the brown wire to the terminal marked L
or coloured red.
Do not connect either wire to the earth terminal in the
plug, marked E (or e) or coloured green (or green
and yellow).
Before replacing the plug cover, make certain that the
cord grip is clamped over the sheath of the lead - not
simply over the two wires.
Copyright in the U.K.
Recording and playback of material may require consent.
See Copyright Act 1956 and The Performer's Protection
Acts 1958 to 1972.