Installation Instructions; Required Tools For Installation; Accessories - GE AUH2436ZGDA Instructions D'installation

Installation Instructions

Required Tools for Installation

• 18-8 thermostat wire
• 5/8" (16mm), 7/8" (22mm), 1" (25mm) or Adjustable
Wrench
• R-410A Refrigerant*
• Adhesive tape*
• Conduit cable clamp 1/2"*
• Copper line set (for size, see table on page 15)
• #2 phillips screwdriver
• Drill
• R-410A flaring tool
• Hex wrench
• Hole saw 2 1/4"
• Insulation*
• Refrigerant scale
• Level
• Manifold gauge set
• Measuring tape

Accessories

Outdoor Unit Accessories
Name
Drain Plug
Drainage Connector
Connect Pipe
Connect Pipe
Installation Manual
6
Appearance
Installation
Instructions
• Micron gauge
• Mini-split adapter (5/16"F to 1/4"M)
• Nitrogen*
• Pipe cutter
• PVC pipe
• Razor knife
• Reamer
• Saddle clamp (L.S.) w/ screws
• Sealant, non-expanding (for lineset hole)
• Soap/water solution* or gas leakage detector
• Stud finder
• Torque wrench
• Vacuum pump
• Wire strippers
• All usual and customary HVAC hand and power tools,
meters, and testing devices
* consumable materials
Quantity
3
1
1
1
1
Usage
To plug the unused drain hole
To connect with the hand PVC
drain pipe
To connect with the service
valves to the line set, gas pipe
To connect with the service
valves to the line set, liquid
pipe.
For reference
31-5000483 Rev. 3