Terminal Strip; Wiring Diagram - GE AUH2436ZGDA Instructions D'installation

Installation Instructions
1. Remove the service panel. Route the power and
control wiring through the openings as shown below.
2. Secure the high voltage wire using the clamp provided.
Maintain as much separation as possible between the
high and low voltage wires.
3. Thermostat must energize reversing valve in heat
mode using the "B" terminal.
Power
208/230V L1
1PH L2
60Hz G
31-5000483 Rev. 3

Terminal Strip

The power cords
and the temperature
controller wire should be
fixed by wire clamps.
The power cords
should be fixed by
wire clamps.
The power cords of
outdoor unit get in
from the hold.
The temperature
controller wire get in
from the hole.

Wiring Diagram

Breaker
The power cords of outdoor
unit get in from the lower hole.
L1
L2
Y
B
W1
R
Outdoor
Unit
C
The wires here
should be
bundled with a
tieline.
The temperature
controller wire
gets in from the
upper hole.
Thermostat
17