Installation instructions
Reinstall the oven door
CAUTION
You may need help lifting the door to slide it into the hinge slots. Do not lift by the handle.
4.
Grasp both sides of the door below
the handle; pull the door up and away
from the oven. (Gently rock the door
side to side as needed.)
5.
Set the door, handle down, on the
covered surface you prepared.
6.
Go to Electric connection.
1.
Grasp both sides of the door below
the handle.
2.
At a 45° angle, align the door hinges
with the slots in the bottom corners
of the oven chassis.
3.
Maintaining a 45° angle, slowly insert
the door. A slight drop indicates the
door is engaged in the slots.
4.
Open the door all the way flat. If the
door does not open a full 90°, repeat
Steps 1 – 3.
5.
Flip the hinge locks up-in to the
locked position. (See Remove the
lower oven door, pg. 12.)
6.
Close the oven door.
7.
If the gap between the oven doors is
uneven, remove and reinstall the
lower door. (See Remove the lower
oven door, pg. 12.)
8.
Reconnect the LED wire harness at
the bottom right of the door.
13
English