Putting Into Service; Maintenance - Titan PLC 456 000100 Notice D'installation

6.

Putting into service

max. 7 bar
7.

Maintenance

Spray all link joints and the valve tappet with a fine spray oil at regular intervals.
Polish the contact surfaces of the middle blade no. 70 at regular intervals with fine emery
cloth (400 grit) to remove accumulations of paint and dirt.
This reduces friction during crimping and increases the life of all components.
Tool inspection!
Perform a daily visual inspection of the outside of the unit. The early detection of damaged
parts extends the life of the unit. Replace all damaged parts immediately with Original
TITAN spare parts.
PLC / DCR / SCR
Connect crimper DCR/SCR with included coupling to the
compressed air network. Max. air pressure: 7 bar.
Important!
This crimper may be operated only in combination with a
compressed air maintenance unit, consisting of a
pressure reducer, filter and water separator.
After establishing the connection to the compressed air network,
the DCR/SCR crimper is ready for operation.
H456 EU 07/10
33 / 71