Maintenance; Spare Parts; Wear Parts - IKA-WERKE LR 2000 V Mode D'emploi

Maintenance

The IKA-laboratory system requires little maintenance. Ball bearings are sealed and permanently lubricated. The following bur-
nished parts should be oiled once a month (see fig. 1 and 2):

Spare parts

When ordering spare parts, please quote type of instrument and serial number as well as ident-number of the spare part.
If you require spare parts, please ask for the corresponding service papers for determining spare parts.
Repair
If you require servicing, return the appliance in its original packaging. Storage packaging is not sufficient. Please also use suita-
ble transport packaging.
In case of repair the device has to be cleaned and free from substances which may constitute a health hazard

Wear parts

16
- End plate of telescopic stand
- Clamping ring of telescopic stand
- Washers on rotary point of collets
- Threaded spindle and spindle nuts of container clamping device
- Retaining clips for ULTRA-TURRAX-drive
as well as from caustic constituents.
Designation
b O-ring 17 x 2,5
c O-ring 159 x 6,0
d O-ring 48 x 2,0
e O-ring 37 x 2,0
f O-ring 26 x 2,0
g Centering ring
Designation
h Plug
i Plug
j Wiper
k Wiper
l Container guideway
a PS-SEAL high-efficiency
sealing
Fig. 4
Id.No.
(FKM)
25 104 00
25 118 00
25 119 00
25 112 00
25 115 00
25 894 00
Id.No.
NS 29/32 19 707 00
NS 14/32 19 710 00
25 053 00
25 052 00
25 069 00
19 206 00
Id.No.
(FFPM)
24 983 00
24 986 00
24 988 00
24 984 00
24 985 00
25 184 00