Description Of The Appliance; Assembling The Appliance - ARIETE 4162 Mode D'emploi

given off by oil-based paints, solvents or waterproofing agents, or by flammable
power or other toxic or explosive fumes.
• Be very careful if you use the appliance with the aid of a ladder.
• Fill up the tank with water before starting up the appliance. Be sure to unplug the
appliance before pouring water into the tank.
• Turn on the appliance only when it is in working position.
• Never leave the appliance unattended when it is connected to the power supply.
• When you have to leave for even a short period of time, turn off the appliance and
always unplug the electric power cord.
• Store the appliance indoors in a cool and dry place.
• sAve these instructiOns fOr future refer-
ence.

DescriptiOn Of the AppliAnce

A - Steam ON/OFF button
B - Handle
C - Cord storage hook
D - Handle release button
E - Tank cap
F - Water tank
G - Motor body
H - On light
I - Cord storage hook
J - Steam head
K - Washable cloth
L - Power cord
M - Steam adjustment knob
N - Steam discharge nozzle
O - Washable cloth velcro couplings
P - Carpets cleaning accessory
Q - Water measure

AsseMbling the AppliAnce

Proceed as follows after removing the appliance from the box:
Assemble the motor body to the steam head (Fig 2). Tighten the screw supplied to lock the components (Fig 3).
Warning!
Check the tightening of the screw from time to time.
Press the handle release button (D). Lift the handle until it is aligned with the motor body (Fig 4-5).
instructiOns fOr use
Totally unwind the power cord. Fill the tank with cool tap water up to the level indicated by MAX (Fig 6). Use the measuring
unit provided. Alternatively, tilt and remove the tank (Fig 7). Remove the cap (E). Fill the tank up to the MAX level directly
beneath the tap with cool tap water (Fig 8). Close the tank with the rubber cap.
Warning!
NEVER fill the tank beyond the MAX level. In the case of particularly calcareous waters (with hardness greater than
20°f) use a mixture composed of 50% of tap water and 50% of demineralised water.
Put the tank back in, paying attention to match the tank valve with the pin in the appliance seat (Fig 9). Press the tank all the
way down until it is completely inserted and check that it is correctly installed.
Place the cloth under the steam head (Fig 10). Set the cloth above the velcro couplings.
13