Sagi ME70LT Manuel D'utilisation Et D'installation page 99

• activate the defrost by hand
• view information pertaining to the HACCP alarms
• delete the HACCP alarm list
• modify the working setpoint
These operations provoke the visualization of the label "Loc" 1 s.
To unlock the keyboard:
• press and
ELIWELL
The keypad can be locked by programming the 'LOC' parameter.
With the keypad locked you can still access the 'Machine Status' menu by pressing
point, but you cannot edit them.
To disable the keypad lock, repeat the locking procedure.
WORKING SETPOINT AND CONFIGURATION PARAMETERS (EVERY CONTROL)
Setting the working setpoint
make sure the keyboard is not locked and no procedure is running
press LED
press or
after changing the value, confirm by pressing
You also can modify the working setpoint through parameter SP.
Working setpoints
LABEL MIN. MAS.
r1 r2
Setting configuration parameters
To gain access the procedure:
make sure no procedure is running
press and
press
press or
press or do not operate 15 s
press and
To select a parameter:
press or
To modify a parameter:
press
press or
press or do not operate 15 s.
To quit the procedure:
press and
Parametri di configurazione
LABEL MIN. MAS.
SP r1 r2
LABEL MIN. MAS.
o1 -25 25
P1 0 1
P2 0 1
LABEL MIN. MAS.
r0 0.1 15
r1 -99 r2
(only low temperature models)
2 s: the display will show "UnL" 1 s.
will flash
, within 15 seconds to change the temperature value.
U.M. DEF.
°C/°F (1) 0
4 s: the display will show "PA"
in 15 s to set "-19"
4 s: the display will show "SP"
in 15 s
4 s or do not operate 60 s.
U.M. DEF.
°C/°F (1) 0
U.M. DEF.
°C/°F (1) 0
- 0
- 0
U.M. DEF.
°C/°F (1) 3
°C/°F (1) 0
(only low temperature models)
"POSITIVE TEMPERATURE 0/+10°C" (48a)
, or avoiding any operation for 15 seconds.
WORKING SETPOINTS
working setpoint
WORKING SETPOINTS
working setpoint
MEASURE INPUTS
cabinet probe offset
decimal point Celsius degree (for the quantity to show during the normal operation) (1=
YES)
unit of measure temperature (2)
MAIN REGULATOR
working setpoint differential
minimum working setpoint
7
to display the Set
(0=°C, 1=°F)