Remington MB4130 Manuel D'instructions page 6

ENGLISH
• Using your other hand, hold the trimmer to the base of your neck with the
cutting unit facing up and move the trimmer up the length of the neck until
it touches your finger covering the hair roots at the base of your head.
• Be sure to move the unit slowly when performing this operation and to
keep the roots at the base of your head out of the way of the trimmer.
, TO DEFINE THE BEARD/MOUSTACHE LINE
• Hold the trimmer with the trimmer blade facing you.
• Start with the edge of beard/moustache line and gently lower the trimmer
blade onto your skin.
• Use motions towards the edge of the beard/moustache line to trim to
desired locations in facial area and away from beard in neck area.
, BLADE RELEASE
• Ensure the trimmer is switched off.
• Remove the adjustable comb.
• Remove the blades by pushing your thumb upwards under the blades and
move the blade set away from the trimmer body.
• To reattach the blades, align the back of the blades with the back housing at
the top of the trimmer and push down until the blade set clicks into place.
E TIPS FOR BEST RESULTS
• Beard, moustache and sideburn hairs should be dry.
• Avoid using lotions before use.
• Comb your hair in the direction that it grows.
C CARE FOR YOUR TRIMMER
• To ensure long lasting performance of the trimmer, clean the blades and unit
regularly.
• Ensure the appliance is switched off and unplugged from the mains.
• Do not use harsh or abrasive cleaners on the unit or blades.
• This product has washable blades. Ensure the blades are detached from the
trimmer before washing the blades.
• Wash the blades under a running tap to remove any hair clippings.
• After rinsing under a tap ensure the blades are dry.
• Do not rinse while the product is connected to the mains.
• Please note the main body of the trimmer is not washable and should be
kept away from water.
• After each use, it is recommended to clean hair from the blades either by
rinsing the blades or using a cleaning brush.
6