Remington MB4130 Manuel D'instructions page 5

ENGLISH
, TO THIN AND TAPER THE BEARD/MOUSTACHE
• Attach an attachment comb to the trimmer blade.
• Use the zoom wheel to set the trimmer comb to the desired length setting.
• The setting will appear on the length position indicator. If you are trimming
for the first time start with the maximum trimming length setting.
STUBBLE AND BEARD LENGTH SETTINGS
• Turn the unit on.
• Place the flat top of the trimmer comb against the skin.
• Slowly slide through the hair. Repeat from different directions as necessary.
• If hair builds up in the trimmer comb during the trimming process, switch
the unit off, pull the comb and brush the hair off.
, Note: Use the beard trimmer without the adjustable comb for trimming hair
close to the skin. This will trim hair to 1mm, holding the blades
perpendicular to the skin will trim hair to 0.4mm.
, TRIMMING THE NAPE OF YOUR NECK
, Note: you will need a hand mirror for this operation if performing it alone.
• Remove the fixed combs or adjustable comb from the wide trimmer. Use
your fingers to lift the hair at the base of your head up off the neck.
• Your index finger should be covering the roots of the hairs you are lifting to
prevent accidental removal by the beard trimmer.
1.5mm
2mm
2.5mm
3mm
4mm
6mm
8mm
10mm
12mm
15mm
18mm
5