Battery Charger; Intended Use; Packaging Content; Parts - Cartrend 50132 Mode D'emploi

BATTERY CHARGER

• The charger is not intended for use by young children or infirm persons without supervision. They do not understand or recognize possible risks of
handling the battery charger.
• Before charging, make sure the input is within stipulated rating level, otherwise charging performance may be seriously affected.
• While connecting the charger to the battery, maintain correct polarity connection and avoid short- circuiting.
• Disconnect the battery from the charger when charger is not connected to the mains.
• Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
• Always disconnect battery charger from the mains before starting any installation, maintenance or cleaning.
• Do not attempt to charge any other batteries than described in the chapter „Intended Use".

2) INTENDED USE

• The battery charger is intended to charge a variety of 12 V sealed lead acid (SLA) batteries, used in cars, motorbikes and other vehicles.
• With this charger it is possible to charge these various batteries at different ambient temperature also in cold conditions to almost 100% of their
original capacity.
• It is a 5-step fully automatic switch mode charger which adjusts itself to charging current and voltage requirement to charge and maintain the
battery.
• The charger is able to recover slightly sulphated batteries, to diagnose and rescue drained battery and to provide trickle charge and maintenance
charge, which increases battery life.
Battery types
SLA (Sealed lead acid):
• WET/FLOODED (Liquid electrolyte)
• GEL (Gelatine type electrolyte, absorbed into the plates)
• AGM (Absorbed glass mat)
• MF (Maintenance free)

3) PACKAGING CONTENT

1 Battery charger
1 Power cord with power plug
1 Instruction manual
Check all parts for transport damage. In case of damage contact your dealer immediately. Check the package for completeness. Inform your dealer
about missing parts immediately.

4) PARTS

1 Indication display
2 Battery charger
3 Power cord
4 Mounting holes
5 Power cord with power plug
6 Pole quick clamp (red),
with built in terminal screw
7 Pole quick clamp (black), with built in terminal screw
8 Pole connection cable (red) with ring terminal
9 Pole connection cable (black) with ring terminal
Battery capacity range
12 V / 1.2 Ah – 12 V / 120 Ah
1 pole connection cable with ring terminal (red)
1 pole connection cable with ring terminal (black)
1 pole quick clamp with built-in terminal screw (red)
1 pole quick clamp with built-in terminal screw (black)
1
9
8
7
6
25
2
3
4
5
GB