Thermo Fisher Scientific TSG Série Manuel D'installation Et Fonctionnement page 14

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. Use local PPE protocols and the appropriate number of
people to gently slide the unit towards the side edge of
the pallet. Slide the unit so that there are approximately 3
inches of overhang to allow the removal of the factory
installed feet and installation of the casters.
CAUTION: Appropriate number of people are
always required to move the unit. Never move or
adjust unit when some one is working on the unit
(i.e. adjusting casters).
DANGER: Do not tip unit more than 10 degrees
during caster installation. Overturning may result
in serious injury or death.
5. Use local PPE protocols and the appropriate number of
people where needed to ensure additional unit support is
provided on the side of the pallet. Remove all the 4
factory installed feet (If necessary use the 3/8" wrench to
loosen). Install 2 casters on overhang edge and tighten
using caster wrench supplied.
Note: Some casters lock and others do not. It is
recommended to install the locking casters on the front of the
unit.
6. While supporting the unit, carefully slide the unit until the
casters reach the ground. Gently slide the back edge off
of the pallet approximately 3 inches to allow for
installation of the back caster. Use local PPE protocols
and the appropriate number of people to continue
supporting the unit at the floor end and install 1 caster on
General Purpose and Chromatography Refrigerators
the back of the unit. Tighten using caster wrench
supplied.
7. Gently rotate unit to install the last caster.
With local PPE protocols and the appropriate number of
people continue supporting the unit at the floor end,
install 1 caster on the front of unit. Tighten using caster
wrench supplied.
8. Take a cardboard packaging corner, fold in half, and
place under the pallet/unit with the fold away from the
pallet. Gently position unit parallel with the pallet using the
edge of the unit to support the pallet. Once in position,
gently roll the unit off of the pallet.
Installation |
9

Publicité

Chapitres

Table des Matières
loading

Table des Matières