Mounting The Counters On The Screw Terminals - ADEUNIS LoRaWAN AS-923 Pulse Guide Utilisateur

LoRaWAN AS-923 Pulse - Guide utilisateur / User guide version V1.0.0

5.3. Mounting the counters on the screw terminals

Once the nut and packing seal are installed, the strands of the meter cable can be connected to the screw terminals of the product.
Below is the identification of each terminal block:
Note: Up to 2 meters of the same type can be used in parallel.
Below is a description of the terminal blocks:
Meter with 2-wire output
In this configuration, it is necessary to deactivate the input TAMPER of channel A (register 320 bit 3 = 0) and preferably deactivate channel B
(register 320 bit 4=0) which is not no used.
GND
IMPULSE_2 / Black
FRAUD_2 / Yellow
GND / Brown
IMPULSE_1 / White
FRAUD_1 / Green
GROUND / GND
IMPULSE / BF
GND / Brown
IMPULSE_1 / White
FR
EN
Page 89 of 99