Fein WSG10-115 Mode D'emploi page 22

3 41 01 117 21 0.book Seite 22 Dienstag, 13. September 2011 8:13 08
en
22
Using the cut-off wheel guard (FIgure 12).
For cut-off grinding operations, always
work with the cut-off wheel guard
mounted.
Before beginning to work, push the
cut-off wheel guard onto the already
mounted wheel guard for grinding.
Grinding (Figure 13).
Keep to an angle of tilt of 20 – 40°. In
this way you will obtain a good removal.
Press the power tool on evenly and
move it over the surface.
Do not allow the surface of the work-
piece to become too hot.
Cutting (Figure 14).
Always work against the direction of
rotation so that the cutting wheel does
not jump out of the cut.
Fig. 12
Wheel guard
for grinding
Fig. 13
20°– 40°
Fig. 14
Cut-off wheel
guard