Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Eclipse Installation & Operations Manual
experience complications see TROUBLE SHOOTING Section 4D.
7. After the system has been set for the correct flow rate. Remove
the Flow Meter Assembly and connect the remaining end of the
Ozone Tube to the Ozone Outlet Barb on the DEL Eclipse unit with
the tube clamp provided. Cut off the excess tubing so that the line
from the injector to the DEL Eclipse is as straight and free from
dips and loops as possible. Ensure that all tube connections are
secured with clamps.
SECTION 3 Operation
3A. General
To achieve optimal performance from the ozone system, the pool
must be as clean as possible to start with.
1. Backwash or clean filters one day before starting the ozone
generator.
2. Superchlorinate pool water using a chlorine based shock treatment
prior to ozone system start-up.
3. Test pool chemistry and adjust pH between 7.4 and 7.6. Adjust
total alkalinity between 80 and 120 ppm.
4. Run pool filtration continuously for 24 hours prior to starting ozone
system.
3B. Initial System Start-Up
Upon completing all of the generator system connections and
cleaning the pool as outlined above, you are ready to start the ozone
generator.
1. Check electrical connections.
2. Check for proper voltage.
3. Turn on pool circulation system.
3C. Normal Operation
1. Indicator Lights: When the pool's circulation system starts, the
Eclipse will power up and the green indicator lights on the ozone
cells will illuminate. Open the Enclosure Door to verify that all
indicator lights are green. The EC-10, EC-20, and EC-40 should
show 2, 4, and 6 indicators, respectively.
3D. System Shut-Down
The following sequence of steps must be followed for servicing or for
4-2162-01 Rev.E
6
Publicité
Chapitres
Table des Matières
