Publicité
Les langues disponibles
Les langues disponibles
SWING
- Press "SWING" Switch
heater will swing from left to right with the LED indicating
Press it again, swing will stop.
TIMER
-In working condition, press
machine enter into time setting mode.
-When the figure for countdown time flashes on the LED, you can now adjust the
countdown time by pressing
Switch to decrease the value. For example, if you set the countdown time
for 1 hour, your heater will turn off automatically in 1 hour. The maximum allow for
countdown setting is 12 hours.
Press
key to quit timer setting, and timer that you have set will effect at once.
-
-If there is no operation to the keys after 5 seconds or press other keys except
and
have set. It will decrease 1h per time, if the timer turns to value 0, then the device
will turn off at once, and enter into standby mode.
- Press
key, the timer setting is finished, and enter into temperature setting.
- You can also use the remote control to activate the differente controls.
- To stop the heater, push again the ON/OFF switch
- Unplug the product when it's not in use
CLEANING & MAINTENANCE
- Always disconnect appliance from the main when you clean it.
- In order to avoid any hazard, only clean the appliance with a dry rag lightly
humidified. NEVER IMMERSE THE HEATER TO CLEAN IT
- To avoid any electrical hazard, clean your appliance with a soft and clean rag to
remove the dust. You can also use a vacuum cleaner to clean the air openings.
- Clean your appliance regularly.
- Attention should be drawn to the environmental aspects of battery disposal
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authority or retailer
for recycling advice.
on the top panel control when the heater is on, the
key, the time indicator
Switch to increase the value and pressing
,then the LED indicator will show the timer that you
76
will be on and the
,
Publicité
