Napoleon P-E Série Instructions D'installation Et D'opération page 37

5.2.2 Condenser Fan Removal
21
To remove condenser fan, heating
module must be removed first.
Refer to steps 1-16 shown in "Heating
Module Removal".
24
Remove 4 rear manifold screws (one from the top).
26
Un-install four screws that holding
heating module upper bracket .
Remove the bracket.
28
Pull out condenser fan assembly.
22
Remove two screws holding
side manifold cover baffle.
27
Remove condenser fan shroud
mounting screws
(3 on the top and 7 at the bottom).
29
Thread the wiring out from both holes
completely out of the fan module.
23
Remove side manifold cover baffle.
25
Remove rear manifold cover baffle.
30
Remove condenser fan part.
W415-2288 / 08.29.2019
37
IOM