Packaged Unit Installation - Napoleon P-E Série Instructions D'installation Et D'opération

4.7

PACKAGED UNIT INSTALLATION

Procedure
1. Verify that isolation grommets are installed in the five holes on the
top mounting bracket.
2. Bring the Condo Pack as close as possible to wall opening (FIG.
4.6.A). Carefully slide the unit into the Wall Sleeve (refer to "4.4
Wall Sleeve Assembly and Installation") so the front of the unit is in
contact with the front flanges of the Wall Sleeve.
For ease of installation (OPTIONAL):
a. Install cabinet into the Wall Sleeve without HEATING unit.
b. Furnace module can be removed separately (FIG. 4.6.B).
Refer to section "5.2.1 Heating Module Removal".
Heating
Module
3. Use a flat washer with each 1/4"-20 x 1 1/4" screw. Secure Condo
Pack unit to the Wall Sleeve using five 1 1/4" screws through
the isolation grommets in the five holes on the Wall Sleeve top
mounting bracket (see FIG. 4.6.C).
OVER-TIGHTENING THE SCREWS WILL
DEFORM THE ISOLATION GROMMETS AND
REDUCE THEIR EFFECTIVENESS.
4. Caulk and seal all spaces around the top, sides and bottom of the
exterior grille area, making sure that the openings for drainage in
the bottom edge are not blocked.
5. Shim (FIG. 4.6.D) between unit support (Diagram B) and the bottom
rear corners of cabinet to prevent twisting loads onto structural walls.
Heating Module Removal.
Furnace module can be removed from cabinet separately.
Refer to "5.2.1 Heating Module Removal".
NOTE
FIG. 4.6.A
FIG. 4.6.B
1/4"-20 x 1 1/4"
Grommet
Flat Washer
FIG. 4.6.C
FIG. 4.6.D
W415-2288 / 08.29.2019
23
IOM