Set Time / Date; Setting The Duration Of The Whirlpool Session - Timer - Teuco 630 Manuel De L'utilisateur

SET TIME / DATE

Press the "Menu/OK" key on the control panel until a
list of functions is shown on the display.
By pressing the keys ▲ and ▼ ▼, select the writing
"G/M MODIFICATION".
When selecting the writing, it starts blinking.
Press "Menu/OK" key to access.
Using the keys ► and ◄, select the value to be
modified. Through the keys ▲ and ▼ set the required
value and press "Menu/OK" to confirm and return to
the main menu.
Should deviations occur between the minipool
clock and another one for reference over time,
a calibration can be carried out by changing the
frequency of the inner clock
Set the "CAL" (calibration) value inserting the value,
expressed in seconds, corresponding to the deviation
between the two clocks occurred in a six-month period.

SETTING THE DURATION OF THE WHIRLPOOL SESSION - TIMER

The procedure for setting duration of whirlpool
session is listed hereunder:
1) Press OK/MENU button
2) Select the PARAMETER line through the
arrows ▲▼
3) Press OK/MENU button
4) Move the blinking cursor to the whirlpool
session duration time through the arrow ►
5) Set the required whirlpool session duration
between 15 and 30 minutes with the arrows
▲▼
6) Press OK/MENU button
7) Select the line YES with the arrows ▲▼ to
confirm the new setting, otherwise select
NO and enter a new value to continue.
8) Press OK/MENU button
630
00:00 01/03/2015
XXXXXXXXXX
G/M MODIFICATION
XXXXXXXXXX
CC9 COUNTER
RC9 C9V=+0000
C9
XXX P=0027
EN
39