Water Treatment - Teuco 630 Manuel De L'utilisateur

EN
10. Bleeding the filter
Turn the bleed valve located on the
the filter cap.
Take care over this step, as an
accumulation of air in the filter can
cause the system to malfunction
seriously and shorten the life of
the pump.
Repeat the operation several times if
necessary.
After bleeding the filter, set the pump
switch to the "AUTO" position.

WATER TREATMENT

Treat the water using the products supplied by Teuco, as described in the accompanying manual.
Other equivalent proprietary products can also be used.
The pH value and Chlorine level must be tested chemically at frequent intervals to guarantee the quality of
the water is properly maintained and ensure correct operation of the system.
630
35