Starting Up First Time - Version With Cartridge Filter - Teuco 630 Manuel De L'utilisateur

EN

STARTING UP FIRST TIME - VERSION WITH CARTRIDGE FILTER

This procedure must be carried out when the system is first started up, and following any operations
that require the pool, the overflow tank, the filter and the recirculation pump to be drained completely.
1. REMOVE THE CANVAS FROM THE MINIPOOL
See "Minipool Canvas".
2. ISOLATE THE SYSTEM FROM THE POWER
SUPPLY
Set the main switch to the "OFF" position.
3. CLOSE THE VALVES
Close all section valves along the various pipelines.
4. FILLING THE MINIPOOL
Fill the pool until the water is up to the rim.
5.
Continue filling the pool, allowing the water to spill
over the edge and away to the overflow tank.
Stop filling the pool when the water reaches the
level of the first metal reinforcing hoop.
6.
Open all valves along the pipelines, except for the
system drain valve, and check that there are no leaks
from pipes or fittings.
7. POWERING UP THE SYSTEM
Set the filter pump switch to "STOP".
Power up the control panel by setting the main switch
to "ON".
The filler solenoid valve will cut in automatically to
bring the water up to operating level in the overflow
tank.
36
630