Kenwood kMixTTM02 Série Instructions page 4

before plugging in
G
Make sure your electricity supply is
the same as the one shown on the
underside of your toaster.
G
WARNING: THIS APPLIANCE
MUST BE EARTHED.
G
This appliance conforms to EC
Regulation 1935/2004 on materials
and articles intended to come into
contact with food.
Use the carriage lever to lift the toast
to Peek & View™ at any time
without cancelling the toasting cycle.
before using for the first time
1 Clip excess cord into the cord
storage clips in the base
G
Operate the toaster once on a
medium setting without bread. (The
lever will not stay down unless the
toaster is plugged in).
G
As with all new heating elements,
your toaster may emit a slight
burning smell when it is first
switched on. This is normal and not
a cause for concern.
key
removable warming rack/toast rack
warming rack handle
Peek & View™ carriage lever
browning control
cancel button with indicator light
crumb tray
cord storage
to use your toaster
1 Plug the toaster into the power
supply.
2 Move the browning control to the
desired setting. Use a low setting
for light toasting and for thin or dry
bread.
3 Insert the bread, muffins, bagels etc.
4 Lower the lever until it locks
'cancel' button will illuminate. (The
lever will not stay down unless the
toaster is plugged in).
G
To toast frozen bread, move the
browning control to the defrost
position
G
Use the carriage lever to lift the toast
to Peek & View™ at any time
without cancelling the toasting cycle.
G
To stop toasting during the cycle,
press the 'cancel' button, the toast
will pop up and the 'cancel' button
light will go off.
5 Your toast will pop up
automatically, to raise it higher, lift
the lever.
hints on using your
toaster
G
. Select a lower setting for light
browning, for toasting one slice only
or for dry bread.
G
When toasting a single slice of
bread, you may notice a variation in
toast colour from one side to the
other - this is normal.
G
Dry/stale bread toasts more quickly
than fresh bread and thinly sliced
bread toasts more quickly than
thickly sliced bread. Therefore the
browning control should be set at a
lower setting than usual.
G
For best results ensure that the
bread slices are of an even
thickness, freshness and size.
G
In order to achieve uniform browning
we recommend you wait a minimum
of 30 seconds between each
toasting so that the control can
automatically reset. Alternatively
select a lower setting when
additional toasting is carried out.
warming rack safety
1 Never set the browning control
higher than 3 when using the
warming rack.
2 Never completely cover the warming
rack.
3 When using the warming rack, never
wrap the food up. Plastic wrapping
will melt and could catch fire. Foil will
reflect heat, damaging the toaster.
4
.
. The