Festo AS-Interface ASI-EVA Manuel D'installation page 24

Please note the following:
– The length of the load voltage cable (depends on the
current consumption and the fluctuations in the load
voltage).
– Fit Festo cable caps ASI-KK-FK or cable sleeves ASI-KT-
FK to open ends of cables. In this way you can avoid
leakage currents and comply with protection class
IP65.
3.7 Configuring the additional power supply (load voltage)
Setting
2)
With load voltage
(factory setting)
Without load voltage
(Seal the "24V DC" con-
nection with blanking plug
type ASI-SD-FK-BL)
1)
Black = pressed
2)
The outputs/valves are provided with power via the addi-
tional supply
3)
The outputs/valves are provided with power via the AS-In-
terface bus
24
1)
DIL switch setting
1, 2: Off
On
3, 4: On
Off
3)
1, 2: On
On
3, 4: Off
Off
Festo ASI-EVA... 0105NH English