Operating Procedures; G Communications With Customers (Talk); G Communications With Other Store Personnel (Page) - Panasonic WX-CT2020 Manuel D'instructions

OPERATING PROCEDURES

G Communications with Customers
(TALK)
Any store personnel wearing the headset can communicate
bidirectionally with any customer who is at the menu board.
1. Select a proper sound level by pressing the button + or
–.
2. You will hear a tone in the headset when a vehicle
arrives at the menu board.
Note: The tone duration varies depending on the set-
tings made in the center module.
<When the Talk PTT mode is preset>
1. Hold down the button T and speak to the customer.
A short beep is heard in the headset.
Hold down
2. Release the button. Your voice will not be heard by the
customer.
Release
<When the Talk Lock mode is preset>
1. Press the button T and speak to the customer.
A short beep is heard in the headset.
Press
2. Press the button again. The lock will be released, and
your voice will not be heard by the customer.
Press again
G Communications with Other Store
Personnel (PAGE)
Store personnel wearing the headset can communicate
with each other without being heard by customers.
<When the Page Lock mode is preset>
1. Press the button P and speak into the microphone of
headset at a normal level.
A short beep is heard in the headset to notify all store
personnel that the system operates in the page mode.
Press
2. Press the button P again. The lock will be released, and
your voice will not be heard by the customer.
Press again
<When the Page PTT mode is preset>
1. Hold down the button P and speak into the microphone
of headset at a normal level.
A short beep is heard in the headset to notify all store
personnel that the system operates in the page mode.
Hold down
2. Release the button. Your voice will not be heard by the
customer.
Release
Notes:
• Transmission using the talk button T or P is allowed for
a single headset at a time. A continuous beep or dis-
torted sound will be heard in a headset when a person
wearing the headset presses the button T or P while
another person is operating.
• Maintain a distance of more than 0.3 m {1 ft.} between
the headset and the order taker, or more than 1 m {3 ft.}
between the headset and the center module.
• Prior to operating the order taker unit, confirm that the
system setup for the order taker unit, center module,
and other devices has been completed.
11