Tank Emptying - Viper AS5160 Manuel Utilisateur

USER MANUAL
Battery discharge during operation
Until the green warning light (A, Figure10) stays on, the
batteries allow the machine to work normally. When the
green warning light (A) turns off, and the yellow warning
light (B) turns on, it is advisable to charge the batteries,
because the remaining charge will last for a few minutes
(depending on battery characteristics and work to be
performed). When the red warning light (C) turns on,
batteries are fully discharged. After a few seconds, the
brush/pad-holder is automatically tuned off, while the (only
for machine with traction) drive system stay on, to finish
drying the floor and drive the machine to the appointed
recharging area.
CAUTION!
Do not use the machine with discharged
batteries, to avoid damaging the batteries
and reducing the battery life.

TANK EMPTYING

An automatic float shut-off system (A, Figure11) blocks the
vacuum system when the recovery water tank (B) is full. The
vacuum system deactivation is signaled by a sudden increase
in the vacuum system motor noise frequency, also the floor
has not dried.
CAUTION!
If the vacuum system turns off accidentally
(for example, when the float is activated
because of a sudden machine movement), to
resume the operation: turn off the vacuum
system by pressing the switch (D, Figure
10), then open the cover (C, Figure 11) and
check that the float inside the grid (A) has
gone down to the water level. Then close the
cover (C) and turn on the vacuum system
by pressing the switch (D, Figure 10).
When the recovery water tank (B, Figure11) is full, empty it
according to the following procedure.
Recovery water tank emptying
1. Stop the machine.
2. Lift the brush/pad-holder deck (E, Figure10) by
pressing the pedal (F).
3. Lift the squeegee (G) with the lever (H).
4. Drive the machine to the appointed disposal area.
5. Empty the recovery water tank with the hose (I). Then,
rinse the tank (B, Figure11) with clean water.
D
E
G
16
ENGLISH
C B A
I
Figure 10
C
B
A
Figure 11
H
F